3D Printed Spoked Wheel - 2 7/8" OD

Each wheel weighs ~12g with tire.  Tires are also 3D printed and are hollow.   Tires can be glued on to rims with CA.
Front side of wheel is coned, rear face is flat.  Spokes are tapered from back to front face.
Axle hole is for 3/32" wire axle, but can be drilled out to 1/8".
Hub width is ~0.375", hub diameter ~0.4", rim ~2.5" OD (2.375" at bottom of tire grove).

NOTE: 3D printed parts can have some slight variability on surface finish and may have some whisps of plastic "flash" which can be removed with a sharp knife.